Hyundai Equus Manuals

Hyundai Azera: Evaporator Core Repair procedures - Heater - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Evaporator Core Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Evaporator Core Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
3.
When the engine is cool, drain the engine coolant from the radiator.
4.
Remove the heater & blower assembly.
(Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")
5.
Remove the blower unit (B) from heater unit after loosening 3 screws.

6.
Loosen the heater unit lower case mount screw and then remove the heater unit lower case (A).

7.
Remove the evaporator core (A).

   
•
Be careful that the inlet and outlet pipe are not bent during evaporator core removal / installation.
8.
Installation is the reverse order of removal
   
-
If you're installing a new evaporator, add refrigerant oil (ND-OIL8).
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
-
Immediately after using the oil, replace the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle ; it may damage the paint ; if the refrigerant oil contacts the paint, wash it off immediately
-
Apply sealant to the grommets.
-
Make sure that there is no air leakage.
-
Charge the system and test its performance.
-
Do not interchange the inlet and outlet heater hoses and install the hose clamps securely.
-
Refill the cooling system with engine coolant
Heater Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recovery/ recycling/ charging station. 3. When the engine is cool, drain the engine coola ...

Temperature Control Actuator Components and Components Location
Component Location ...

See also:

Smart Cruise Control Unit Repair procedures
Removal 1. Remove the bumper. (Refer to Body - "Front Bumper Cover") 2. Loosen the bolts and nuts and then remove the smart cruise control unit assembly (A) from the vehicle. 3. Disconn ...

Spark Plug Repair procedures
Removal and Installation 1. Remove the ignition coils. (Refer to Ignition System - "Ignition Coil") 2. Using a spark plug socket, remove the spark plug. Tightening torque : 14.7 ~ 24.5N. ...

Rear Oil Seal Repair procedures
Removal 1. Remove the drive plate. (Refer to Cylinder Block - "Drive Plate") 2. Remove the rear oil seal (A). Installation 1. Using SST(09231-3C200, 09231-H1100), install the rear oil s ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com