Hyundai Equus Manuals

Hyundai Azera: Rear Oil Seal Repair procedures - Cylinder Block - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Rear Oil Seal Repair procedures

Removal
1.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).

Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.

   
Always use new oil seal.
2.
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate")
Rear Oil Seal Components and Components Location
Components 1. Rear oil seal2. Oil seal case ...

Cylinder Block Components and Components Location
Components 1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...

See also:

Main Crash Pad Assembly Repair procedures
Replacement     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Steering Angle Sensor Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turnin ...

Repair procedures
On-vehicle Inspection     • Check that the battery cables are connected to the correct terminals. • Disconnect the battery cables when the battery is given a quick ch ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com