Description |
1. |
Heater unit includes mode control actuator and temperature control actuator. |
2. |
Temperature control actuator is located at the heater unit.
It regulates the temperature by the procedure as follows. Signal from
control unit adjusts position of temperature door by operating
temperature switch and then temperature will be regulated by the
hot/cold air ratio decided by position of temperature door |
Transaxle Oil Temperature Sensor Schematic Diagrams
Circuit Diagram
...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle.
This is called the GVWR (Gross V ...
Yaw-rate and G Sensor Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
(Refer the Body - "Floor console")
3.
Disconnect the yaw rate & latera ...