Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the heater and blower unit.
(Refer to Heater - "Heater Unit") |
3. |
Remove the blower unit (A) from the heater unit after loosening a mounting bolt and 3 screws.
|
4. |
Installation is the reverse order of removal. |
Input Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...
Special Service Tools
Special Tools
Tool(Number and Name)IllustrationUse09495-3K000Band installerInstallation of ear type boot band09495-33000PullerRemove the spider assembly from the driveshaft
...
ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode
ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2AP ...