Inspection |
1. |
Connect the battery voltage and check the blower motor rotation. |
2. |
If the blower motor voltage is not operated well, substitute with a known-good blower motor and check for proper operation. |
3. |
If the problem is corrected, replace the blower motor. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B). |
3. |
Disconnect the of the blower motor connector(A) and then remove the blower motor (B). |
4. |
Installation is the reverse order of removal. |
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications
Direct control VFS[T/CON]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 9.81~ 500.14 (0.1~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal res ...
Oil Pump Repair procedures
Removal
1.
Remove the lower oil pan.
(Refer to Lubrication System - "Oil Pan")
2.
Remove the oil pump chain cover (A).
Tightening torque :
9.8 ~ 11.8N.m (1.0 ~ 1.2kgf.m, 7.2 ~ 8.7lb-ft)
...
Side impact air bag
Your vehicle is equipped with a side impact air bag in each front and outboard
rear seat. The purpose of the air bag is to provide occupants with additional protection
than that offered by the sea ...