Hyundai Azera: Power Mosfet Repair procedures
| Inspection |
| 1. |
Ignition "ON" |
| 2. |
Manually operate the control switch and measure the voltage of blower motor. |
| 3. |
Select the control switch to raise voltage until high speed.
Specification
*AUTO COOLING: Auto speed (4.5V~B+)
*AUTO HEATING: Auto speed (4.5V~11.3V) |
| 4. |
If the measured voltage is not specification, substitute with a known-good power mosfet and check for proper operation. |
| 5. |
If the problem is corrected, replace the power mosfet. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B).
|
| 3. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws.
|
| 4. |
Installation is the reverse order of removal. |
Blower Motor Repair procedures
Climate Control Air Filter Description and OperationGauges
Speedometer
The speedometer indicates the vehicle speed.
The speedometer is calibrated in miles per hour and/or kilometers per hour.
Tachometer
The tachometer indicates the engine speed in rev ...
Canister Close Valve (CCV) Schematic Diagrams
Circuit Diagram
...
Theft-alarm stage
The alarm will be activated if any of the following occurs while the system is
armed.
A door is opened without using the smart key.
A door is opened without using the mechanical key.
The trun ...