Description |
1. |
The intake actuator is located at the blower unit. |
2. |
It regulates the intake door by signal from control unit. |
3. |
Pressing the intake selection switch will shift between recirculation and fresh air modes. |
Rear Oil Seal Repair procedures
Removal
1.
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate")
2.
Remove the rear oil seal (A).
Installation
1.
Using SST(09231-3C200, 09231-H1100), install the rear oil s ...
TPMS Sensor Repair procedures
Removal
1.
Remove the tire.
(Refer to Tires/Wheels - "Tire")
2.
Remove the valve nut.
The valve nut should not be re-used.
Installation
Sensor Fit
& ...
Hands Free Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the steering wheel.
(Refer to Steering System - "Steering Column and Shaft")
3.
Remove the cover (A) after loosening scre ...