The main intent is to prevent the vehicle from rolling backwards while driving uphill on an inclined surface. HAC holds the braking pressure built up by the driver when the vehicle is stopped for 2 seconds after releasing the brake pedal. During the pressure-hold period, the driver has enough time to depress the accelerator pedal to drive off.
The braking pressure is reduced as soon as the system detects the driver’s intention to drive off.
WARNING - Rolling backward
Drivers should pay close attention when activating the HAC. The vehicle may roll backward causing an accident due to insufficient brake hold pressure, causing injury or death.
Rear Door Latch Repair procedures
Replacement
1.
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module")
2.
Disconnect the rear door latch connector (A).
3.
Remove the rear door latch assembly (A).
4.
I ...
Tilting the sunroof
When the sunshade is closed
If you push the sunroof control lever upward, the sunshade will slide all the
way open then the sunroof glass will tilt.
To stop the sunroof movement at any point, p ...