Hyundai Equus Manuals

Hyundai Azera: Vehicle stability management (VSM) - Brake system - Driving your vehicle - Hyundai Azera 2011-2025 Owners ManualHyundai Azera: Vehicle stability management (VSM)

This system provides further enhancements to vehicle stability and steering responses when a vehicle is driven on a slippery road or a vehicle detects changes in coefficient of friction between right wheels and left wheels when braking.

VSM operation

When the VSM is operating:

The VSM does not operate when:

VSM operation off

If you press the ESC OFF button to turn off the ESC, the VSM will also cancel and the ESC OFF indicator light ( ) will illuminate.
) will illuminate.

To turn on the VSM, press the button again. The ESC OFF indicator light goes out.

Malfunction indicator

The VSM can be deactivated even if you do not cancel the VSM operation by pressing the ESC OFF button. It indicates that a malfunction has been detected somewhere in the EPS (Electronic Power Steering) system or VSM system. If the ESC indicator light (on, take your vehicle to an authorized HYUNDAI dealer and have the system checked.) or EPS warning light remains
on, take your vehicle to an authorized HYUNDAI dealer and have the system checked.

WARNING - Tire/wheel sizes

When replacing tires and wheels, make sure they are the same size as the original tires and wheels installed. Driving with varying tire or wheel sizes may diminish any supplemental safety benefits of the VSM system.

Electronic stability control (ESC)
The Electronic Stability Control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC appli ...

Hill-start assist control (HAC)
The main intent is to prevent the vehicle from rolling backwards while driving uphill on an inclined surface. HAC holds the braking pressure built up by the driver when the vehicle is stopped for 2 ...

See also:

ICM (Integrated Circuit Module) Relay Box Repair procedures
Inspection Two Turn Unlock Relay Check for continuity between the terminals. 1. There should be continuity between the No.18 and No.17 terminals when power and ground are connected to the No. ...

Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coola ...

Wheel nut tightening torque:
65~79 lb·ft (9~11 kg·m) If you have a tire gauge, remove the valve cap and check the air pressure. If the pressure is lower than recommended, drive slowly to the nearest service station and inflate ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com