Hyundai Equus Manuals

Hyundai Azera: Crankshaft Damper Pulley Repair procedures - Timing System - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Crankshaft Damper Pulley Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Repair procedures

Removal and Installation
   
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
   
Mark all wiring and hoses to avoid misconnection.
1.
Remove the battery and battery tray.
2.
Remove the engine cover.
3.
Remove the air duct and air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
4.
Remove the engine room under cover.
5.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler")
6.
Remove the crankshaft damper pulley (A).
Tightening torque :
284.4 ~304.0N.m (29.0~31.0kgf.m, 209.8~224.2lb-ft)

   
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.
•
Install the SST (09231-2B100) to hold the ring gear after removing the starter.

•
Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.
1.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler")
2.
Remove the dust cover (A) on the bottom of the upper oil pan and unfasten the two transaxle mounting bolts (B).

3.
Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.
4.
Fasten the two transaxle mounting bolts in the original mounted holes.

5.
Install the SST (09231-3D100) using the two mounting bolts. Tighten the bolts and nuts of the holder securely.

7.
Install in the reverse order of removal.
Crankshaft Damper Pulley Components and Components Location
Components 1. Crankshaft damper pulley ...

Front Oil Seal Components and Components Location
Components 1. Front oil seal ...

See also:

MEDIA MODE
Pressing the key will change the operating mode in order of CD➟USB(iPod®)➟AUX➟My Music ➟ BT Audio. If [Mode Pop up] is turned on within [Display], then pressing t ...

Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to reach this equipment. (1) Jack handle (2) Jack (3) Wheel lug nut wrench Jacking ...

SS-B Solenoid Valve(ON/OFF) Description and Operation
Description SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com