Hyundai Azera: Rear Oil Seal Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Repair procedures
| Removal |
| 1. |
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate") |
| 2. |
Remove the rear oil seal (A).
|
| Installation |
| 1. |
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.
|
| 2. |
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate") |
Rear Oil Seal Components and Components Location
Components
1. Rear oil seal2. Oil seal case
...
Cylinder Block Components and Components Location
Components
1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...
See also:
Seat Heater Components and Components Location
Component Location
...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com