Removal and Installation |
1. |
Disconnect the battery negative terminal. |
2. |
Remove the engine room under cover. |
3. |
Disconnect the heated oxygen sensor (HO2S) connector.
|
4. |
Remove the front muffler (A).
|
5. |
Install in the reverse order of removal. |
Components and Components Location
Component Location
Components
1. Heater Case (LH)2. Heater Case (RH)3. Separator4. Heater Case (Lower)5. Drain Hose6. Insulation7.Shower Duct (RH)8. Temp Actuator(PA)9. Temp Door Cam10. Evapora ...
Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light ...
Searching Categories
Select the category by using the
, keys and press the
key to select.
Channels for the selected category are played. ...