Removal |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the ventilation hose (A) from the fuel tank air filter. |
3. |
Disconnect the vapor tube quick-connector (B) and the quick-connector (C). |
4. |
Remove installation bolts (A) and then remove the canister assembly. |
5. |
Remove the bracket (A) from the canister after removing a bolts (B). |
Inspection |
1. |
Check for the following items visually.
A: Canister - Atmosphere
B: Canister - Fuel Tank
C: Canister - Intake Manifold
|
Installation |
1. |
Installation is reverse of removal. |
Canister installation bolt :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lb-ft) |
Rear curtain (if equipped)
To fold the rear curtain, press the button. To unfold the rear curtain, press
the button again.
CAUTION
Do not pull or fold the rear curtain by hand. It could cause motor failure.
The rear ...
Oil Pressure Switch Components and Components Location
Components
1. Oil cover2. Oil cover gasket3. Oil pressure switch
...
Fender Garnish Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...