Hyundai Azera: Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams

Manifold Absolute Pressure Sensor (MAPS) Specifications

Specification Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)20.0 (0.20, 2.90)0.7946.66 (0.47, 6.77)1.84101.32 (1.03, 14.7)4.0 ...

Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ConditionOutput Voltage (V)IG ONApprox. 4.44VIdleApprox. 0.75V ...

See also:

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Good braking practices
WARNING Whenever leaving the vehicle or parking, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. Vehicles not fully eng ...

Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside) 1. Disconnect the negative (-) battery terminal. 2. If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A). ...