Hyundai Azera: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the manifold absolute pressure sensor connector (A). |
| 3. |
Remove the installation bolt (B), and then vertically remove the sensor from the surge tank.
|
| Installation |
|
|
| 1. |
Installation is reverse of removal.
|
Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Engine Coolant Temperature Sensor (ECTS) Description and OperationHazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop
the car in a hazardous location. When you must make such an emergency stop, always
pull off the road as far as poss ...
GVW (Gross vehicle weight)
This is the Base Curb Weight plus actual Cargo Weight plus passengers. ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Description and Operation
Description
Overdrive clutch control solenoid valve(OD/C) is attached to
the valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the overdrive clutch. ...