Hyundai Azera: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the manifold absolute pressure sensor connector (A). |
| 3. |
Remove the installation bolt (B), and then vertically remove the sensor from the surge tank.
|
| Installation |
|
|
| 1. |
Installation is reverse of removal.
|
Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Engine Coolant Temperature Sensor (ECTS) Description and OperationESC Control Module Components and Components Location
Components
1. Front - left tube2. Rear - right tube3. Rear - left tube4. Front - right tube5. MC26. MC17. ESC control module (HECU)8. Damper9. Bracket
...
Digital clock (if equipped)
WARNING
Do not adjust the clock while driving. You may lose your steering control
and cause an accident that results in severe personal injury or death.
Whenever the battery terminals or relate ...
Components and Components Location
Component Location
Components
1. Heater Case (LH)2. Heater Case (RH)3. Separator4. Heater Case (Lower)5. Drain Hose6. Insulation7.Shower Duct (RH)8. Temp Actuator(PA)9. Temp Door Cam10. Evapora ...