Hyundai Equus Manuals

Hyundai Azera: Engine Coolant Temperature Sensor (ECTS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Engine Coolant Temperature Sensor (ECTS) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the ECTS connector.
3.
Remove the ECTS (Refer to "Removal").
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
5.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the air cleaner assembly.
3.
Disconnect the engine coolant temperature sensor connector (A).
4.
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
   
•
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.

5.
Supplement the engine coolant.
Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine coolant to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.
Engine coolant temperature sensor installation:
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Circuit Diagram ...

Crankshaft Position Sensor (CKPS) Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine ...

See also:

If engine does not turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and ti ...

Front Seat Assembly Repair procedures
Replacement 1. Remove the front seat track mounting cover. 2. After loosening the seat assembly mounting bolts, remove the front seat assembly (A). Tightening torque : 49.0 ~ 63.7N.m (5.0 ...

Front seat
Automatic adjustment The front seat can be adjusted by using the control switch located on the door and outside of the seat cushion. Before driving, adjust the seat to the proper position so as to ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com