Removal |
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”) |
2. |
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B). |
3. |
Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup. |
4. |
Remove the return nozzle (B) after releasing the fixing hook (A). |
5. |
Remove the reservoir-cup (B) after releasing the fixing hooks (A). |
6. |
Remove the pre-filter (C) after releasing the fixing hooks (A,B).
|
7. |
Separate the electric pump motor (A) and regulator (B) from the fuel filter (C). |
8. |
Disconnect the connector (A), and then remove the head assembly (B). |
Installation |
1. |
Installation is reserve of removal. |
Ashtray
To use the ashtray, open the cover. To clean or empty the ashtray, pull it out.
Do not use the vehicle’s ashtray as waste receptacles.
WARNING - Ashtray use
Putting lit cigarettes or matches in an ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found, ...
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...