Hyundai Azera: Transaxle Control Module (TCM) Repair procedures
| Inspection |
| 1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
|
| 2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it. |
| 3. |
If problem is not found in Step 1 and 2, the TCM could be
faulty. If so, make sure there were no DTC's before swapping the TCM
with a new one, and then check the vehicle again. If DTC's were found,
examine this first before swapping TCM. |
| 4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be
broken) into a known-good vehicle and check the vehicle. If the problem
occurs again, replace the original TCM with a new one. If problem does
not occur, this is intermittent problem (Refer to “Intermittent
Problem Inspection Procedure� in Basic Inspection Procedure). |
| Replacement |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the negative (-) battery cable. |
| 3. |
Disconnect the TCM connector (A).
|
| 4. |
Remove the Transaxle Control Module(TCM) (C) after removing the mounting bolts (A) and nut (B).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Transaxle Control Module (TCM) Schematic Diagrams
Transaxle Oil Temperature Sensor Description and OperationEngine compartment
1. Engine oil dipstick
2. Engine oil filler cap
3. Engine coolant reservoir
4. Radiator cap
5. Brake fluid reservoir
6. Windshield washer fluid reservoir
7. Air cleaner
8. Positive battery te ...
High mounted stop light replacement
If the light bulb does not operate, have the vehicle be checked by an authorized
HYUNDAI dealer.
A skilled technician should check or repair the high mounted stop light. Otherwise,
it may affect ...
Waist Line Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...