Transaxle oil temperature sensor monitors the automatic
transaxle fluid's temperature and conveys the readings to TCM. It is an
Negative Thermal Coefficient(NTC) sensor whose resistance has an
inversely proportional relationship with the temperature level. Data
produced by this sensor is used to identify damper clutch activation and
deactivation zones within the low temperature and high temperature
range and to compensate hydraulic pressure levels during gear changes.

Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure
1.
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector a ...
Specifications
? Type: Negative Thermal Coefficient(NTC) Type
Temp.[(°C)°F]Resistance (k?)(-40)-4048.1(-20)-4.015.6(0)32.05.88(20)68.02.51(40)104.01.11(60)140.00.61(80)176.00.32(100)212.00.18(12 ...
See also:
TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-L ...
Brake fluid
Check brake fluid level in the brake fluid reservoir. The level should be between
“MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid
conforming to DOT 3 or DOT 4 spec ...
High Mounted stop lamp Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the connector (A) of high mounted stop lamp.
4.
R ...