Hyundai Azera: Dynamic Damper Components and Components Location
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and Components Location
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and Components Location
| Components |
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot | 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band | 9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case | 13. Circlip |
TJ Joint Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new on ...
Dynamic Damper Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Using a ...
See also:
Front Hub - Axle Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire(A) from front hub.
Tightening torque:
88.2 ...
Smart Cruise Control Switch Schematic Diagrams
Circuit Diagram
...
Components and Components Location
Component Location
1. Fender
...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com