Hyundai Azera: Rear Shock Absorber Repair procedures
| Replacement |
| 1. |
Remove the rear wheel & tire (A).
|
| 2. |
Loosen the bolt and then remove the variable damper bracket (A).
|
| 3. |
Loosen the bolt & nut and then disconnect the shock absorber (A) with the rear axle.
|
| 4. |
Loosen the shock absorber mounting bolts (A).
|
| 5. |
Installation is the reverse of removal. |
| Inspection |
| 1. |
Check the rubber parts for wear and deterioration. |
| 2. |
Compress and extend the piston rod(A) and check that there is no abnormal resistance or unusual sound during operation.
|
| 1. |
Fully extend the piston rod |
| 2. |
Drill a hole on the (A) section to remove gas form the cylinder.
|
Rear Shock Absorber Components and Components Location
Rear Upper Arm Repair proceduresFront Driveshaft Components and Components Location
Component Location
1. Driveshaft(LH)2. Inner shaft bearing bracket assembly3. Driveshaft(RH)
Components
1. BJ Assembly2. Clip3. BJ Boot Band4. BJ Boot5. Dynamic Damper Band6. Dynamic Damp ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS failure.
2.
When ESC or TCS fails, only the failed system control is prohibited.
3.
However, when the ...
Glass antenna
When the radio power switch is turned on while the ignition switch is in either
the “ON” or “ACC” position, your vehicle will receive both AM and FM broadcast signals
through the antenna in ...