Hyundai Azera: General Information
| General | 
| 1. | 
 DC/DC converter: DC/DC converter in power supply unit 
includes up/down transformer converter, and provide ignition voltage for
 2 front airbag ignition circuits and the internal operation voltage of 
the SRSCM. If the internal operation voltage is below critical value 
setting, it will perform resetting.  | 
| 2. | 
 Back up power supply: SRSCM has separate back up power 
supply, that will supply deployment energy instantly in low voltage 
condition or upon power failure by front crash.  | 
| 3. | 
 Self diagnosis: SRSCM will constantly monitor current SRS 
operation status and detect system failure while vehicle power supply is
 on, system failure may be checked with trouble codes using GDS.   | 
| 4. | 
 Airbag warning lamp on: Upon detecting error, the module will
 transmit signal to SRSCM indicator lamp located at cluster. MIL lamp 
will indicate to the driver of SRS error. Upon ignition key on, SRS lamp
 will turn on for about six seconds.  | 
| 5. | 
 Trouble code registration: Upon error occurrence in system, 
SRSCM will store DTC corresponding to the error. DTC can be cleared only
 by GDS. However, if an internal fault code is logged or if a crash is 
recorded, the fault code(s) cannot be cleared.  | 
| 6. | 
 Self diagnostic connector: Data stored in SRSCM memory will 
be output to GDS or other external output devices through connector 
located below driver side crash pad.  | 
| 7. | 
 Once airbag is deployed. The SRSCM should not be used again and should be replaced.  | 
| 8. | 
 SRSCM will determine whether passenger put on the seat belt 
by the signal from built-in switch in the seat belt buckle, and deploy 
front seat airbag at each set of crash speed.  | 
| 9. | 
 Side airbag deployment will be determined by SRSCM that 
detects satellite sensor impact signal upon a side crash, irrespective 
to seat belt condition.  | 
SpecificationsGeneral Information
   Basic Service Symbols
There are five primary symbols used to complement 
illustrations. These symbols indicate the part to apply such materials 
during service.
SymbolMeaningDo not reuse the p ...
   
Rear Door Module Components and Components Location
   Component Location 
1. Rear door module
 ...
   
General Information
   Lift And Support Points
Lift And Support Points
    
When heavy rear components such as suspension, fuel tank, 
spare tire, tailgate and trunk lid are to be removed, place additi ...