Hyundai Azera: Seat Belt Buckle Switch (BS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Description and Operation
| Description |
The SRSCM shall monitor the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status input. The seat belt
buckle circuit operates from internal boost voltage supplied by the
SRSCM, and uses chassis ground for the signal return. The buckle status
shall modify the SRSCM deployment. If the buckle status is unbuckled,
the corresponding pretensioner will not be deactivated.
Side Impact Sensor (SIS) Repair procedures
Removal
Front Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to Body - "Door sc ...
See also:
Rear Curtain Repair procedures
Inspection
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper op ...
Valve Body Repair procedures
Removal
1.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
2.
Remove the under cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ...
Description and Operation
Description
Exhaust emissions (CO, HC, NOx) are controlled by a
combination of engine modifications and the addition of special control
components.
Modifications to the combustion chamber, int ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com