Hyundai Azera: Anchor Pretensioner (APT) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Seat Belt Pretensioner / Anchor Pretensioner (APT) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Restraint / Seat Belt Pretensioner / Anchor Pretensioner (APT) Description and Operation
| Description |
Front seat belt anchor pretensioner operates as well as belt
pretensioner at the same time If it gets into its deploy condition after
a collision. It is located at near anchor on front seat and it is an
equipment to make up for the existing short stroke. Front seat belt
anchor pretensioner is an auxiliary equipment to prevent the driver and
passenger from breaking away doubly as seat belt is being pulled toward
anchor side after a collision.
Never measure resistance of anchor pretensioner directly, current of measuring device may cause unexpected airbag deploy. |
Seat Belt Pretensioner (BPT) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Left side - Remove the seat belt lower anchor cover (A).
After loosening the ...
Anchor Pretensioner (APT) Components and Components Location
Components
...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications
Direct control VFS[T/CON]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 9.81~ 500.14 (0.1~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal res ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Relay Box (Engine Compartment) Components and Components Location
Components
...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com