Hyundai Azera: Brake Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Brake System / Brake System / Brake Switch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Brake System / Brake System / Brake Switch Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the lower crash pad.
|
| 3. |
Disconnect the stop lamp switch connector (A).
|
| 4. |
Pull the locking plate (A) as indicated by the arrow.
|
| 5. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
| Installation |
| 1. |
Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
|
| 2. |
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
|
| 3. |
Confirm the gap between stop lamp switch and bracket.
|
| 4. |
Connect the stop lamp switch connector.
|
| 5. |
Install the lower crash pad.
(Refer to the Body - "Crash Pad") |
Rear Disc Brake Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Loosen the bolt & nut and then disconnect the shock absorbe ...
See also:
BJ Boot Components and Components Location
Components
[LH]
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...
Fuel Pressure Control Valve (FPCV) Troubleshooting
Signal Waveform
...
Injector Drive Box (IDB) Repair procedures
Removal
1.
Turn the ignition switch off and disconnect the battery negative (-) cable.
2.
Disconnect the injector drive box (IDB) connector (A).
3.
Remove the air cleaner assembly.
(Refer ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com