Replacement |
1. |
Remove the ECM mirror cover (A). |
2. |
Disconnect the ECM mirror connector (B). |
3. |
Loosen the ECM mirror mounting screw (A). |
4. |
Push the ECM mirror base up to remove the ECM mirror assembly (A). |
5. |
Installation is the reverse of removal.
|
Schematic Diagrams
MDPS Circuit Diagram
Harness Connector
TypePin NoDescriptionBattery1Battery +2Battery -Vehicle1IGN2-3-4-5-6-7High_CAN8Low_CAN
...
Repair procedures
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch.
2.
If diagnosis is ...
Rail Pressure Sensor (RPS) Specifications
Specification
...