Hyundai Equus Manuals

Hyundai Azera: Passenger Airbag (PAB) Module Repair procedures - Airbag Module - Restraint - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Passenger Airbag (PAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
3.
Remove the passenger airbag mounting bolts (A).

4.
Disconnect the passenger airbag connector (A) and active vent connector (B).

5.
Remove the crash pad.
   
Replace the crash pad which is damaged while PAB is deployed.
6.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.
   
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts (A).

Tightening torque
: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Install the crash pad.
5.
Tighten the passenger airbag mounting bolts.

Tightening torque
: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-.ft)

6.
Connect the passenger airbag harness connector to the SRS main harness connector.
7.
Reinstall the glove box housing.
8.
Reconnect the battery negative cable.
9.
After installing the passenger airbag (PAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Passenger Airbag (PAB) Module Components and Components Location
Components ...

Side Airbag (SAB) Module Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag b ...

See also:

Rear parking assist system (If equipped)
The rear parking assist system assists the driver during reverse movement of the vehicle by chiming if any object is sensed within a distance of 47 in. (120 cm) behind the vehicle. This system is ...

Components and Components Location
Components 1. Front pillar trim2. Center pillar upper trim3. Rear pillar trim4. Cowl side trim5. Center pillar lower trim6. Front door scuff trim7. Rear door scuff trim ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com