Hyundai Equus Manuals

Hyundai Azera: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
1.
Remove the automatic transaxle assembly.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the air breeder hose (A).
3.
Remove the valve body cover (B).
Tightening torque:
12.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.9 lb-ft)

4.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

5.
Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the torque converter control solenoid valve (A).

Installation
1.
Installation is the reverse of removal.
   
•
Check fluid level after fill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Replace the gasket (A) before reinstalling valve body cover.

Torque Converter Control Solenoid Valve (T/CON_VFS) Schematic Diagrams
Circuit Diagram ...

26 Brake Control Solenoid Valve(26/B_VFS) Description and Operation
Description 26 brake control solenoid valve(26/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

See also:

ESCL(Electronic Steering Column Lock) Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud ...

Repair procedures
Inspection (With GDS) 1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. 2. If diagnosis is ...

Description and Operation
Refrigeration Cycle Air Outlet and Air Flow The mode selection switch controls the direction of the air flow through the ventilation System Air FlowSymbolOutletDescriptionVentB,C,D,E,FAir f ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com