Hyundai Azera: Rear Back Armrest Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the connectors (A), and mounting wireing clips (B).

3.	After loosening the mounting screws, then remove the rear back armrest board (A).

4.	After loosening the mounting bolts, then remove the rear back armrest (A).

5.	Remove the rear back armrest board (A) after loosening the screws on the rear back armrest (B).

6.

Installation is the reverse of removal.

•	Make sure the connectors are plugged in properly.

Rear Back Armrest Components and Components Location

Component Location 1. Rear back armrest ...

Rear Back Armrest Cup Holder Components and Components Location

Component Location 1. Rear back armrest cup holder ...

See also:

CVVT Oil Control Valve (OCV) Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by ...

Rear Wheel Speed Sensor Repair procedures
Removal 1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor mounting bolt (A). Tightenin ...

Relay Box (Engine Compartment) Components and Components Location
Components ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com