Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Remove the hole plug (B). |
3. |
After loosening the mounting bolt, then remove the rear door outside handle cover (A).
|
4. |
Remove the rear door outside handle (A) by sliding it rearward. |
5. |
Installation is the reverse of removal.
|
Troubleshooting
Troubleshooting
ProblemPossible causeSolutionNot pairingBluetooth device of Car is not discoverable modeEnter Bluetooth pairing (searching) modeUser’s phone is Bluetooth off modeUser’s phone set ...
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
TPMS Receiver Description and Operation
Operation
1.
General Function
A.
Auto-locate/learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's, together
with their respective road whee ...