Hyundai Azera: Specifications
| Specification |
Air Conditioner
| Item | Specification | |
| Compressor | Type | 6VSX16 |
| Oil type & Capacity | FD46XG(PAG OIL) 100±10cc | |
| Pulley type | 6PK-TYPE | |
| Displacement | 160cc/rev | |
| Condenser | Heat rejection | 14,400 ±5% kcal/hr |
| A/C Pressure transducer | The method to measure the pressure | Voltage= 0.00878835 * Pressure (psig) + 0.5 |
| Expansion valve | Type | Block type |
| Refrigerant | Type | R-134a |
| Capacity [oz.(g)] | 19.4 ± 0.88 oz. (550 ± 25g) | |
Blower Unit
| Item | Specification | |
| Fresh and recirculation | Operating method | Actuator |
| Blower | Type | Sirocco |
| Speed step | Auto + 8 speed (Automatic) | |
| Speed control | Power mosfet (Auto) | |
| Air filter | Type | Particle filter |
Heater And Evaporator Unit
| Item | Specification | |
| Heater | Type | Pin & Tube type |
| Heating capacity | 4,850 - 5% kcal/hr | |
| Mode operating method | Actuator | |
| Temperature operating method | Actuator | |
| Evaporator | Temperature control type | Evaporator temperature sensor |
| A/C ON/OFF [°C(°F)] | ON : 3.0 ± 0.5 (39.4 ± 32.9), OFF: 0 ± 0.5 (32.0 ± 32.9) | |
Tightening torques
| Part tightened | N.m | Kgf.m | lbf-ft |
| Condenser - Discharge hose | 7.8 ~ 11.8 | 0.8 ~ 1.2 | 5.8 ~ 8.7 |
| Condenser - Liquid tube | |||
| Compressor | 20.0 ~ 32.9 | 2.04 ~ 3.36 | 14.7 ~ 24.3 |
| Compressor - Suction hose | 7.8 ~ 11.8 | 0.8 ~ 1.2 | 5.8 ~ 8.7 |
| Compressor - Discharge hose | |||
| Expansion valve - Evaporator | 8.8 ~ 13.7 | 0.9 ~ 1.4 | 6.5 ~ 10.1 |
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of limiter assembly.
...
See also:
Sunvisor
Use the sunvisor to shield direct light through the front or side windows. To
use a sunvisor, pull it downward. To use a sunvisor for a side window, pull it downward,
unsnap it from the bracket ...
Panoramaroof Switch Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Check for continuity between the termin ...
Repair procedures
Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left.
2.
Adjust the hood height by turning the hood overslam bumpers (C).
...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com