Hyundai Azera: Trunk Lid Assembly Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Assembly Repair procedures

Replacement

•	When removing and installing the trunk lid, an assistant is necessary.

•	Wear gloves to protect hands from injury.

1.	After loosening the mounting screws, then remove the trunk inside handle (A).

2.	Detach the clips, then remove the trunk lid trim (A).

3.	Detach the clips, then remove the trunk lid side cover (A).

4.	Disconnect wiring (B) and connectors.

5.

After loosening the mounting bolts, then remove the trunk lid (A).

Tightening torque :

6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)

6.

Installation is the reverse of removal.

•	Replace any damaged clips.

Trunk Lid Assembly Components and Components Location

Component Location 1. Trunk lid assembly ...

Trunk Lid Trim Components and Components Location

Component Location 1. Trunk lid trim ...

See also:

Battery saver function
The purpose of this feature is to prevent the battery from being discharged. The system automatically turns off the parking lights when the driver turns off the engine and opens the driver-side ...

Output Speed Sensor Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the battery and the battery ...

SRS Control Module (SRSCM) Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Ref ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com