Hyundai Equus Manuals

Hyundai Azera: Trunk Lid Trim Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Trunk Lid Trim Repair procedures

Replacement
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
1.
After loosening the mounting screws, then remove the trunk inside handle (A).

2.
Detach the clips, then remove the trunk lid trim (A).

3.
Installation is the reverse of removal.
   
Replace any damaged clips.
Trunk Lid Trim Components and Components Location
Component Location 1. Trunk lid trim ...

Trunk Lid Latch Components and Components Location
Component Location 1. Trunk lid latch ...

See also:

Valve clearance
Inspect excessive valve noise and/or engine vibration and adjust if necessary. An authorized HYUNDAI dealer should perform the operation. ...

Care of seat belts
Seat belt systems should never be disassembled or modified. In addition, care should be taken to assure that seat belts and belt hardware are not damaged by seat hinges, doors or other abuse. WARNI ...

Crankshaft Position Sensor (CKPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal 1. Turn the ignition switch OFF and disconnect the battery n ...

Categories

Hyundai Azera Manuals

2011-2026 Copyright www.hgmanual.com