Hyundai Azera: Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2. Release both buttons. Do not hold for longer than 20 seconds.
The Integrated HomeLink® Wireless Control System is now in the training (learn) mode and can be programmed at any time following the appropriate steps in the Programming sections above.
FCC ID: NZLTLMHL4 IC: 4112A-TLMHL4
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may cause undesired operation.
WARNING
The transceiver has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
NVS® is a registered trademark and Z-Nav™ is a trademark of the Gentex Corporation, Zeeland, Michigan. HomeLink® is a registered trademark owned by Johnson Controls, Incorporated, Milwaukee, Wisconsin.
Reprogramming a single HomeLink® button
Outside rearview mirrorWarnings and indicators (lnstrument cluster)
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
HYUNDAI dealer. After starting the e ...
Using My Music Mode
Playing/Pausing My Music Files
While playing, press the key to
pause and press again to play.
✽ NOTICE
If there are no files saved within My Music, the
button will be disabled.
Changi ...
Front Driveshaft Components and Components Location
Component Location
1. Driveshaft(LH)2. Inner shaft bearing bracket assembly3. Driveshaft(RH)
Components
1. BJ Assembly2. Clip3. BJ Boot Band4. BJ Boot5. Dynamic Damper Band6. Dynamic Damp ...