Hyundai Azera: Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Hood / Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Hood / Repair procedures
| Adjustment |
| 1. |
After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up or down, or right or left. |
| 2. |
Adjust the hood height by turning the hood overslam bumpers (C). |
| 3. |
After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up or down, or right or left.
|
Hood
...
Hood Assembly Components and Components Location
Component Location
1. Hood assembly
...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Tire terminology and definitions
Air Pressure:
The amount of air inside the tire pressing outward on the tire. Air pressure
is expressed in pounds per square inch (psi) or kilopascal (kPa).
Accessory Weight:
This means the comb ...
Engine Mounting Repair procedures
Removal and Installation
[Engine mounting support bracket]
1.
Install the jack to the edge of upper oil pan (A) to support the engine.
Insert the rubber block between jac ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com