Hyundai Equus Manuals

Hyundai Azera: Hood Assembly Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Hood Assembly Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement
   
•
When removing and installing the hood, an assistant is necessary.
•
Be careful not to damage the hood and body.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).

2.
After loosening the hood hinge (A) mounting bolts, remove the hood panel (B).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

3.
Installation is the reverse of removal.
   
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the hood alignment.
Hood Assembly Components and Components Location
Component Location 1. Hood assembly ...

Hood Insulator Pad Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A).     • Be careful not to scratch the hood panel. 2. Installation is th ...

See also:

Windshield wiper/washer
A :Wiper speed control MIST – Single wipe OFF – Off INT – Intermittent wipe LO – Normal wiper speed HI – Fast wiper speed B : Intermittent wipe time adjustment C :Wash with b ...

Inhibitor Switch Schematic Diagrams
Circuit Diagram ...

Injector Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within t ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com