Hyundai Azera: Hood Latch Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Detach the clips, then remove hood latch cover (A).

3.

Remove the hood latch (A) mounting bolts.

Tightening torque :

7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Disconnect the hood latch cable (A) and remove the hood latch (B).

5.

Installation is the reverse of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

•	Adjust the latch alignment.

Hood Latch Components and Components Location

Component Location 1. Hood latch ...

Trunk Lid

...

See also:

Heated Steering wheel Repair procedures
Inpection 1. Measure a resistance of NTC and Heated pad. A. NTC resistance(Black / Yellow, Black) - 10.0 k? ± 10% (25°C) B. Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 ? ± 10% 2. ...

Engine Hanger Repair procedures
Removal and Installation [Front engine hanger] 1. Remove the front engine hanger (A) Tightening torque: 44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft) 2. Install in the reverse ord ...

Water Jacket Seperator Repair procedures
Removal 1. Remove the LH/RH cylinder head assembly and gasket. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket seperator (A). Installation 1. Install the ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com