| • |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
| • |
Put on gloves to protect your hands. |
| • |
Take care not to scratch the body surface. |
|
| 1. |
Remove the front tire. |
| 2. |
After loosening the mounting clips and screws, then remove the front wheel guard (A). 
|
| 3. |
Installation is the reverse of removal.
| • |
Replace any damaged clips. |
|
|
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
See also:
Power Door Lock Switch Repair procedures
Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of DDM/ADM with GDS
quickly. GDS can operates actuator forcefully, input/output value
monitoring and self diagnosis.
2. ...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery n ...
Coolant
The coolant should be changed at the intervals specified in the maintenance schedule. ...
Hyundai Azera: Front Wheel Guard Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Front Wheel Guard Repair procedures
Fender Garnish Repair procedures
Rear Wheel Guard Repair procedures