Hyundai Azera: Rear Seat Back Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Back Cover Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Disconnect the connectors (A), and mounting wireing clips (B).

3.	After loosening the mounting screws, then remove the rear back armrest board (A).

4.	After loosening the mounting bolts, then remove the rear back armrest (A).

5.	Push the lock pin (B), remove the headrest (A).

6.	After loosening the mounting screws, then remove the rear seat back webbing guide (A).

7.	Pull out the headrest guides (A) while pinching the end of the guides, and remove them.

8.	Remove the hog-ring clips (A).

9.	After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat back and remove the rear seat back cover (C).

10.

Installation is the reverse of removal.

•	To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].

Rear Seat Back Cover Components and Components Location

Component Location 1. Rear seat back cover ...

Rear Seat Cushion Cover Components and Components Location

Component Location 1. Rear seat cushion cover ...

See also:

Side Airbag (SAB) Module Repair procedures
Removal Front Side Airbag 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat assembly. (Refer to Body - "Front seat as ...

Airbag Module Disposal Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airba ...

Intake Manifold Repair procedures
Removal and Installation 1. Remove the surge tank. (Refer to Intake And Exhaust System - "Surge Tank") 2. Remove the low pressure fuel line. (Refer to Fuel System - "Fuel Line") 3. Rem ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com