Smart Key |
1. |
Connect the DLC cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. |
2. |
Select the vehicle model and then do "Smart key code saving". |
3. |
After selecting "Smart key teaching" menu, push "Enter" key, then the screen will be shown as below. |
4. |
After pushing the SSB with the teaching key, press "OK" button. |
5. |
Input the "Pin code" for first key teaching. |
6. |
Confirm the message "First key teaching completed". |
7. |
Input the "Pin code" for second key teaching. |
8. |
Confirm the message "Second key teaching completed". |
9. |
Then the screen will be shown as below when key teaching process is completed. |
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Hood Latch Release Handle Repair procedures
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
...
Using AUX Mode
Press the key
Select [AUX]
An external device can be connected to play music.
✽ NOTICE
If an external device connector is connected with the AUX terminal, then
AUX mode will ...