Hyundai Azera: Power Seat Control Switch Schematic Diagrams

Power Seat Motor Repair procedures

Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Front height motor B : Slide motor C : Rear height motor D : Recline motor E : Lumbar support motor F : Cushion ...

Power Seat Control Switch Repair procedures

Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Lumb ...

See also:

Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures recomm ...

SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valver connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank") 3. Disconnect the vapor hose (A). 4. Remove ...