Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper.
|
3. |
Disconnect the front fog lamp connector. |
4. |
Replace the front fog bulb (A) turning it in the counterclockwise direction. |
5. |
Remove the front fog lamp (A) after removing the screws (4EA). |
Installation |
1. |
Install the front fog bulb. |
2. |
Reconnect the lamp connector. |
3. |
Install the front wheel housing. |
Inspection |
1. |
Check BCM input/output specification of MFSW using the GDS.
(Refer to Multifunction switch - "Multifunction switch") |
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one or two minutes, and then stop it. If
the pedal depress ...
Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your
loaded vehicle weight within its design rating capability. Properly loading your
vehicle will provide maximum return o ...
Description and Operation
Description
Front blind camera is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind camera will operate when you push the button
and shi ...