Hyundai Azera: Immobilizer Control Unit Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening the nut.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector. |
| 2. |
Install the crash pad lower panel.
|
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner.
The procedure starts with a ...
Antenna Coil Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the 6P connector (B) of the coil ante ...
See also:
Rear Console Cover Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Bluetooth® Wireless Technology Setting
Pairing a New Device
Press the key
Select [Phone]
Select [Pair Phone]
Bluetooth® Wireless Technology devices can be paired with the audio system.
For more information, refer to the “Pairin ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com