Hyundai Azera: Rear Console Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Remove the console rear complete assembly. (Refer to Floor Console - " Floor Console Assembly")

2.	After loosening the mounting screws, then remove the rear console cover (A).

3.	Disconnect the connector (A).

4.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damage clips.

Rear Console Cover Components and Components Location

Component Location 1. Rear console cover ...

Console Armrest Components and Components Location

Component Location 1. Console armrest ...

See also:

If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. ...

Fuel lines, fuel hoses and connections
Check the fuel lines, fuel hoses and connections for leakage and damage. Have an authorized HYUNDAI dealer replace any damaged or leaking parts immediately. ...

Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B) and ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com