Hyundai Equus Manuals

Hyundai Azera: Engine Mounting Repair procedures - Engine And Transmission Assembly - Engine Mechanical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Engine Mounting Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Mounting Repair procedures

Removal and Installation
[Engine mounting support bracket]
1.
Install the jack to the edge of upper oil pan (A) to support the engine.

   
Insert the rubber block between jack and upper oil pan.
2.
Disconnect the ground cable (A), and then remove the engine mounting support bracket (B).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

3.
Install in the reverse order of removal.
[Engine mounting bracket]
1.
Remove the reservoir tank.
(Refer to Cooling System - "Reservoir Tank")
2.
Remove the engine mounting support bracket (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
3.
Remove the engine mounting bracket (B).
Tightening torque:
58.8 ~ 73.5N.m (6.0 ~ 7.5kgf.m, 43.3 ~ 54.2lb-ft)

4.
Install in the reverse order of removal.
[Roll rod bracket]
1.
Remove the engine room under cover.
2.
Remove the roll rod bracket (A).
Tightening torque
Bolt (B):
107.9 ~ 127.5N.m (11.0 ~ 13.0kgf.m, 79.6 ~ 94.0lb-ft)
Bolts (C):
49.0 ~ 63.7N.m ( 5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)

   
Do not reuse : Bolt (B) (Loctited)
3.
Install in the reverse order of removal.
Engine Mounting Components and Components Location
Components 1. Transaxle mounting bracket2. Roll road bracket3. Sub frame4. Engine mounting bracket5. Engine mounting support bracket ...

Engine And Transmission Assembly Repair procedures
Removal     • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. ...

See also:

INTERIOR LIGHT
CAUTION Do not use the interior lights for extended periods when the engine is not running. It may cause battery discharge. WARNING - Interior light Do not use the interior lights when driving in ...

Rear Shock Absorber Components and Components Location
Components 1. Self locking nut2. Bracket assembly3. Bumper rubber4. Dust cover5. Shock absorber ...

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com