Hyundai Azera: Drive Plate Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Repair procedures
| Removal and Installation |
| 1. |
Remove the automatic transaxle.
|
| 2. |
Remove the adapter plate (B) and the drive plate (A).
|
| 3. |
Install in the reverse order of removal. |
Drive Plate Components and Components Location
Components
1. Drive plate2. Adapter plate
...
Rear Oil Seal Components and Components Location
Components
1. Rear oil seal2. Oil seal case
...
See also:
Side Impact Sensor (SIS) Description and Operation
Description
Side Impact Sensor (SIS) system consists of two Pressure Side
Impact Sensor (P-SIS) which are installed at each center of the front
door module (LH and RH) and two SIS which are ins ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON'T remove the camshaft posit ...
Front Driveshaft Components and Components Location
Component Location
1. Driveshaft(LH)2. Inner shaft bearing bracket assembly3. Driveshaft(RH)
Components
1. BJ Assembly2. Clip3. BJ Boot Band4. BJ Boot5. Dynamic Damper Band6. Dynamic Damp ...
Categories
Hyundai Azera Manuals
2011-2026 Copyright www.hgmanual.com