Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAWR. ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...