Hyundai Azera: Variable Intake Solenoid (VIS) Valve Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Description and Operation
| Description |
Variable Intake manifold Solenoid (VIS) valves are installed
on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2).
These VIS valve 1 and 2 control vacuum modulators which activate valves
in the intake manifold and the surge tank. These valves are opened or
closed by ECM according to engine condition (Refer to below table).
CVVT Oil Control Valve (OCV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specifi ...
Variable Intake Solenoid (VIS) Valve Specifications
Specification
ItemSpecificationCoil Resistance (?)30.0 ~ 35.0 [20°C(68°F)]
...
See also:
Rear Seat Back Cover Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and ...
Valve Body Components and Components Location
Components Location
1. PCV adjust screw2. Solenoid valve3. Oil temperature sensor4. Accumulator5. Low & reverse brake(LR/B) pressure flow hole6. Under drive brake (UD/B) pressure flow hole
...
CVVT Oil Temperature Sensor (OTS) Description and Operation
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance
with the ECM control signal which is calculated by ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com