Hyundai Azera: SS-B Solenoid Valve(ON/OFF) Schematic Diagrams

SS-B Solenoid Valve(ON/OFF) Specifications

Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ? Control type : Normal low type Control pressure [kpa (kgf/cm?, psi)]490.33(5.0, 71.12) Internal resistance(?)10~11 ...

SS-B Solenoid Valve(ON/OFF) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valver connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

See also:

BJ Boot Components and Components Location
Components [LH] 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...

Hood Latch Release Handle Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off the post. ...

Power Window Switch Repair procedures
Inspection Driver Power Window Switch 1. When checking the driver power window switch, select a vehicle type and "IPM" menu. 2. Select "DDM (Driver Door Module)". 3. Select option "Input/ ...